ONSEMI NCT75DMR2G Temperature Sensor IC, Open Drain, ± 3°C, -55 °C, +125 °C, MSOP, 8 Pins

The NCT75DMR2G is an industry standard digital temperature sensor with 2�wire interface in 8 pin Micro8 package. It is a two wire serially programmable temperature sensor with an overtemperature/interrupt output pin to signal out of limit conditions. This is an open-drain pin and can operate in either comparator or interrupt mode. Temperature measurements are converted into digital form using a high resolution (12bit), sigma-delta, analogue to digital converter (ADC). Three address selection pins (A2, A1 and A0) can be used to connect up to 8 NCT75 devices to a single bus. Through this interface the NCT75 internal registers may be accessed. These registers allow the user to read current temperature, change configuration settings and adjust temperature limits. Typical applications include computer thermal monitoring, thermal protection, isolated sensors, battery management, office electronics, electronic test equipment, thermostat controls & system thermal management.

• Temperature accuracy of ±1°C
• Supply voltage range of 3V to 5.5V and average supply current of 575µA at 3.3V
• Overtemperature indicator and one-shot mode
• SMBus/I2C interface and support for SMBus/active-low ALERT
• Shutdown mode for low power consumption
• Offers shutdown mode to conserve power
• Temperature resolution of 0.0625°C and temperature conversion time of 48.5ms (one-shot mode)
• Update rate of 80ms
• Typical shutdown current of 3A
• Operating temperature range from -55°C to +125°C

Applications

Sensing & Instrumentation, Consumer Electronics, Portable Devices

Market demand for this product has caused an extension in leadtimes. Delivery dates may fluctuate. Product exempt from discounts.